Luoyang Mingzhen Bearing Steel Ball Co.,Ltd

Products

Knowledge
Home > Industry News > Content

Common Defects and Causes of Steel Balls Blank(Ⅱ)

Source:Luoyang mingzhen bearings steel balls Co.,Ltd | Updated: Jul 20, 2017

Steel Balls Blank.jpg


3. Causes of upsetting: the cutting knife isn’t adjusted properly so that the material can’t be sent to the center of the mold; the bar size is small or the position of the material in the mold is not correct because of larger die wear size; when stamping steel balls blank, the punch spring is loose or damaged and the press hook is not pressed steadily.

4. Burr, rolling and pressure wound: burr mainly refers to the resulting burr due to cutting knife is too blunt and the gap between the main cutting knife and cutting tube is too large or too small after the raw material is cut off. After creating and stamping the burrs, they are involved into the workpiece. The broken burrs fall into the die, causing pressure wound. Rolling cause steel balls blank crack, affecting the quality of steel balls seriously.

5. Causes of displacement and size over tolerance: the machine is not adjusted, the machine has the low precision or the mold is wear seriously. According to reasons for the production, it should be eliminated by adjusting the relative position of the mold or changing the gap of the main slider guide part.

6. There are three kinds of blank cracks: material cracks, upsetting cracks and folding cracks caused by burrs.


Feedback

If you have any enquiry about quotation or cooperation, please feel free to email us at info@mzsteelball.com or use the following enquiry form. Our sales representative will contact you within 24 hours. Thank you for your interest in our products.

Contact Us
Address: Liupo village, Mangling Town, Yanshi, Luoyang, Henan, China.
Tel: +86 (0)379 6439 0720
Fax: +86 (0)379 6439 0720
E-mail:info@mzsteelball.com
Home | About Us | Products | Technical information | Photo Gallery | News & Event | Contact Us | Mobile | XML